Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Perfekte Lösung für deine Trijicon RMR-Montage!
Der NOVAK-STYLE TRIJICON RMR SIGHT MOUNT von EGW ist die ideale Wahl, um dein Trijicon RMR Red Dot Sight sicher und stabil zu montieren.
Produktbeschreibung
- Material: 7075 Aluminium
- Beschichtung: Matte Black Hardcoat
- Gesamtlänge: 1.780"
- Gesamtbreite: 1.1"
- Montagematerial: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
- Red Dot Passform: Trijicon RMR, Holosun HS507C
Kompatibilität
Diese Montage passt auf:
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
Diese Montage passt nicht auf:
Einfach zu installieren
Du kannst einfach die hintere Visierung deines Gewehrs entfernen und durch unsere Montage ersetzen, um dein Trijicon RMR Red Dot Sight zu montieren. Es sind keine Änderungen erforderlich. Du kannst unsere Montage jederzeit abnehmen und deine hintere Visierung wieder anbringen. Montagematerial ist im Lieferumfang enthalten.
Installationsanleitung
- Die hintere Visierung entfernen*
- Die EGW Sight Mount im Dovetail installieren
- Set-Schraube festziehen (falls zutreffend)
- Das Red Dot Sight auf die EGW Sight Mount setzen (ein kleines Stück Papier zwischen dem Red Dot Sight und der Montage erleichtert die Entfernung und hält Loctite vom Red Dot Sight fern.)
- Blaue Loctite auf die mitgelieferten Montageschrauben auftragen
- Montageschrauben mit 15 in/lbs anziehen
Hinweis: Die mit dieser Montage gelieferten Schrauben erfordern einen 5/64'' Inbusschlüssel für die Installation.