Il Carrello è vuoto.

Carrello

0917309915

Suisse / Schweiz

Lingue: Deutsch Français Italiano

SCHUSTER
MA ADJUSTABLE GAS SYSTEM

100001733

Saves Wear On Bolt Lugs & Softens Blow On Op Rod

Vented steel design changes cycle time by letting you adjust the gas volume in the cylinder. Quick adjustment of vent size with integral set-screw; eliminates changing screws for different vent sizes. Reduces battering on op rod, bolt lugs, receiver and trigger group. Available for M1 Garand and M1A.

SPECS: Steel, parkerized finish. Replaces existing gas nut with no modifications to the rifle. Includes adjustment tool and instructions.

Altro...

Salva usura sul bullone alette & ammorbidisce colpo su Op verga

Sfiato modifiche di progettazione in acciaio ciclo tempo consentendo di regolare il volume di gas nel cilindro. Regolazione rapida della dimensione di sfiato con vite integrale; Elimina mutevoli viti per dimensioni delle diverse prese. Riduce percosse su op asta, bullone Anse, ricevitore e gruppo grilletto. Disponibile per M1A e M1 Garand.

Specifiche: acciaio, finitura parkerized. Sostituisce esistenti dado gas con nessuna modifica al fucile. Include istruzioni e strumento di regolazione.

Altro...

Punteggi dei clienti per SCHUSTER M1 ADJUSTABLE GAS SYSTEM

Numero di punteggi: 6
Da brownells.com: 6
Punteggio medio: 4.8

Work great! (24.10.2011)

Using this to adjust the recoil of the op rod, you really can fine tune your M1A with this plug. Works really well, all you have to do is follow the instructions.

Great product! (21.09.2012)

I ordered this for my new Scout Squad. simple install. Took it to the range, it may take several shots to get it set, (normal), from there you're good to go! Worth the money hands down! Great upgrade in my opinion.

Hard to install Adjust Gas Plug, M1A, (24.04.2014)

I bought this product a couple weeks ago to use on my Spfld Arm. inc. M1A and had trouble screwing it in a Military spec. gas cylinder...at first I thought that it was the wrong thread, but a closer comparison revealed that they were correct, just super tight....I used Krills oil on both threads and turning it a 1/8 of a turn at a time using a 1/2" combo wrench it went home....I took the weapon to the range and ran some Tulammo through it. I had to adjust (tune) the valve per instructions and the M1a operated great...it dropped the cases 2 feet away, kinda just barely making it out of the weapon.....no strain on the op rod at all...it is worth the money if you consider how much an M14 op rod cost to replace....

Great device (15.09.2009)

I really like my adjustable gas plug. It softens up the cycling of my garand and lets me shoots commercial ammo safely. The only downside is that I couldn't screw it in with a 1/4 in. drive socket and had to grind a tool out of an old reciprocating saw blade to install it. Overall it is very good.

Makes the M1-A and M-1 Garand New Rifles (02.08.2013)

I have used the Schuster Adjustable Gas System in both the M1-A and the Garand for several years for general shooting and load developement. It is quite simeple to use. Open the gas adjustment screw to the wide open spot by screwing it out until it is within a turn or two of coming out the front end of the gas valve housing. Shoot a round. Obviously, the rifle is not going to go through its semi-auto functions as the valve is venting all the gas. Open bolt, eject the empty case and lock the action open for safe work at the muzzle! Turn the gas valve adjustment screw inward a couple of turns. Fire a shot. The action may start to work, depending upon the gunpowder you are using and bullet weight. Repeat the process turning the adjustment screw in again. Gently, easy does it! Don't turn too far... As you turn the adjustment screw in and then fire a shot,the bolt may start to come back. Repeat the process of screwing the adjustment screw downward. Fire a shot. This time, the bolt may eject the case and close on an empty chamber. Repeat the process. Now turn the adjustment screw fractions of a complete turn downward. Gently now... The bolt may almost lock open! Repeat the process and this time you may be delighted to find the rifle has performed all the semi-auto functions and is locked open, waiting for the next round. NOW, do not change the setting of the adjusment screw. The rifle should lock open again at the next shot. If it does, you are set FOR THIS POWDER CHARGE AND BULLET COMBINATION. If it does not perform all the functions, turn the adjustment screw downward again and lock it in place with the lock nut the is supplied. Make sure you don't get the allen wrench in so far that as you are adjusting the adjustment screw the same time you are trying to set the lock screw on it! Some fine touch is required for this operation! You will use a little more ammo using this system but you will have a rifle that will operate at minumum impact on itself. Do your chronographing at this point. THEN, REMEMBER TO OPEN THE ADJUSTMENT SCREW ALL THE WAY UP TO START OVER WHEN YOU CHANGE LOADS! Maybe you can figure out a way to reset it to the load you just fired. I have not. I just open it up and start again. I love it!

Must Have (18.05.2017)

Must have part for an m1 if you want to shoot it a lot or don't reload and don't have access to surplus. I'm going to tune mine for modern 180 grain hunting loads, since that's the most common ammo I can get. Better to use new ammo too because it's not corrosive or dirty. If you don't have the tool to change the plugs out, a large flathead screwdriver will work. Set screw is a little tricky to get started, but it works well.

Leggi più recensioni su brownells.com

74.9 94.9 2 CHF

N. prodotto: 100001733
SCHUSTER M1 ADJUSTABLE GAS SYSTEM
Parti Fabbricante: 10021 Sfiato modifiche di progettazione in acciaio ciclo tempo consentendo di regolare il volume di gas nel cilindro. Regolazione rapida della dimensione di sfiato con vite integrale; Elimina mutevoli viti per dimensioni delle diverse prese. Riduce percosse su op asta, bullone Anse, ricevitore e gruppo grilletto. Disponibile per M1A e M1 Garand.

74.9 CHF 0 CHF 74.90 *

In arretrato, tempi di consegna circa 4-12 settimane dal magazzino negli Stati Uniti.

Caratteristiche: Adatto per: Springfield Modello: M1 Garand

Aggiungi alla lista degli acquisti

Domande

Dettagli

Aggiungi alla lista degli acquisti

Domande

Caratteristiche

Adatto per: Springfield Modello: M1 Garand Peso della spedizione: 0.023kg Altezza di spedizione: 5mm Larghezza di spedizione: 79mm Lunghezza di spedizione: 130mm

Dettagli dell'elemento

Made in Usa
Classificazione per l'export dagli US: 0A501.x

N. prodotto: 100002329
SCHUSTER M1A ADJUSTABLE GAS SYSTEM
Parti Fabbricante: 10026 Sfiato modifiche di progettazione in acciaio ciclo tempo consentendo di regolare il volume di gas nel cilindro. Regolazione rapida della dimensione di sfiato con vite integrale; Elimina mutevoli viti per dimensioni delle diverse prese. Riduce percosse su op asta, bullone Anse, ricevitore e gruppo grilletto. Disponibile per M1A e M1 Garand.

94.9 CHF 0 CHF 94.90 *

In arretrato, tempi di consegna circa 4-12 settimane dal magazzino negli Stati Uniti.

Caratteristiche: Adatto per: Springfield Modello: M14, M1A

Aggiungi alla lista degli acquisti

Domande

Dettagli

Aggiungi alla lista degli acquisti

Domande

Saves Wear On Bolt Lugs & Softens Blow On Op Rod

SPECS: Steel, parkerized finish. Replaces existing gas nut with no modifications to the rifle. Includes adjustment tool and instructions.

Altro...

Salva usura sul bullone alette & ammorbidisce colpo su Op verga

Specifiche: acciaio, finitura parkerized. Sostituisce esistenti dado gas con nessuna modifica al fucile. Include istruzioni e strumento di regolazione.

Altro...

Punteggi dei clienti per SCHUSTER M1 ADJUSTABLE GAS SYSTEM

Numero di punteggi: 6
Da brownells.com: 6
Punteggio medio: 4.8

Work great! (24.10.2011)

Using this to adjust the recoil of the op rod, you really can fine tune your M1A with this plug. Works really well, all you have to do is follow the instructions.

Great product! (21.09.2012)

Hard to install Adjust Gas Plug, M1A, (24.04.2014)

Great device (15.09.2009)

Makes the M1-A and M-1 Garand New Rifles (02.08.2013)

Must Have (18.05.2017)

Leggi più recensioni su brownells.com

Scelti da altri clientie

TANKS RIFLE SHOP SPRINGFIELD M1 GARAND MAGAZINE 30-06 SPRINGFIELD 8RD STEEL B
SPRINGFIELD M1 GARAND EN-BLOCK CLIP 30-06 SPRINGFIELD

TANKS RIFLE SHOP

Riordinato

CHF 7.90 * CHF 7.90 - CHF 13.90*

Caricatori | Magazines

DEWEY M-1 GARAND 30-06 CHAMBER BRUSH
M1/M1A Chamber Brushes

DEWEY

Riordinato

CHF 17.90 *

Utensili per la pulizia

MERCHANT .30-06 M1 GARAND THROAT GAUGE
THROAT EROSION GAUGE

MERCHANT

In magazzino

CHF 64.90 * CHF 59.90 - CHF 64.90*

Strumento rimozione ruggine canne

4.8

INSTA-MOUNT SCOPE BASES - S&K RUGER® MINI-14® 181 & UP SERIES (WEAVER)

S&K RUGER® MINI-14® 181 & UP SERIES (WEAVER)
INSTA-MOUNT SCOPE BASES

S&K

In magazzino

CHF 84.90 * CHF 74.90 - CHF 109.90*

Basi per carabine

3.7

BROWNELLS METRIC THREAD PITCH GAUGE
STRAIGHT THREAD PITCH GAUGE

BROWNELLS

Riordinato

CHF 25.90 * CHF 25.90 - CHF 27.90*

Pettine per filetti

Accesso

Hai dimenticato la password?
Registrati

SOCIAL MEDIA

Facebook

BROWNELLS.CH

CATALOGO PRODOTTI

ORDINARE

CUSTOMER SERVICE

Benvenuti!

Benvenuti su Brownells.ch, il principale rivenditore online di accessori per armi da fuoco, componenti di pistole e utensili per armaioli in Svizzera!

La nostra offerta

Se ti piace sparare, lavorare sulle armi da fuoco come artigiano o per hobby, o semplicemente possiedi un'arma, questo è il posto per te! Grazie alla nostra grande esperienza, ogni giorno, tiratori, armaioli professionisti, hobbisti, militari, esponenti delle forze dell'ordine e appassionati d'armi si rivolgono a Brownells.ch per trovare accessori e componenti di alta qualità e fare rifornimento di ciò di cui hanno bisogno.