Brownells Svizzera - Il più grande rivenditore di componenti e accessori per armi ed attrezzistica per armieri Suisse / Schweiz

SINCLAIR INTERNATIONAL
SINCLAIR STUCK CASE REMOVAL TOOL

749013572
We developed this handy tool to help solve the reloader’s age-old nightmare; removing a case stuck in the sizing die. This happens when the rim of the case tears off during the downstroke, leaving the case body in the die, with nothing to grab to pull it out. The Sinclair Stuck Case Removal Tool lets you clear that stuck case from any standard sizing die without risk of damaging the die. Just remove the die from the press and back out the decapping pin until it’s out of the flash hole. Clamp the die in a vise and “thread” the primer pocket and flash hole using the included drill and tap, so you can screw the main body of the tool into the hole. As you tighten the cap screw with a standard 3⁄16" hex head wrench, the tool neatly pulls the case out of the die.
29.9 29.9 1 CHF
N. prodotto: 749013572
SINCLAIR INTERNATIONAL STUCK CASE REMOVER Abbiamo sviluppato questo utile strumento per aiutare a risolvere incubo secolare di reloader; rimozione di un caso bloccato nello stampo dimensionamento. Questo accade quando il bordo del caso strappa durante la discesa, lasciando il corpo di case nello stampo, con nulla da afferrare per tirarlo fuori. Lo strumento di rimozione caso bloccato Sinclair consente di chiarire che bloccato caso da qualsiasi ridimensionamento standard die senza rischio di danneggiare il dado. Basta rimuovere lo stampo dalla macchina da stampa e indietro il perno di decapsulatura fino a quando non è fuori dal buco di flash. Fissare il morire in una morsa e un "thread" primer tasca e flash buco utilizzando il trapano incluso e rubinetto, quindi è possibile avvitare il corpo principale dell'utensile nel foro. Come si stringe la vite del coperchio con una 3⁄16 standard "testa esagonale, lo strumento tira ordinatamente il caso fuori lo stampo.
29.9 CHF 0 CHF 29.90 *
In arretrato, tempi di consegna circa 4-12 settimane dal magazzino negli Stati Uniti.

Caratteristiche

Peso della spedizione: 0.126kg Altezza di spedizione: 13mm Larghezza di spedizione: 102mm Lunghezza di spedizione: 152mm

Dettagli dell'elemento

Made in Usa




We developed this handy tool to help solve the reloader’s age-old nightmare; removing a case stuck in the sizing die. This happens when the rim of the case tears off during the downstroke, leaving the case body in the die, with nothing to grab to pull it out. The Sinclair Stuck Case Removal Tool lets you clear that stuck case from any standard sizing die without risk of damaging the die. Just remove the die from the press and back out the decapping pin until it’s out of the flash hole. Clamp the die in a vise and “thread” the primer pocket and flash hole using the included drill and tap, so you can screw the main body of the tool into the hole. As you tighten the cap screw with a standard 3⁄16" hex head wrench, the tool neatly pulls the case out of the die.
Newsletter