Il Carrello è vuoto.

Carrello

0917309915

WILSON COMBAT
1911 MULTI-COMP

874218001674 965397001

Instant Comp & Bushing Give Muzzle Control, Less Recoil

Three full chambers and seven exhaust ports combine to help control recoil and muzzle climb to put you back on target faster. Installation is as easy as fitting a new barrel bushing. Fits all calibers of Govt.-length barrels with O.D. of .576" to .580". Requires minor fitting and a full-length, two-piece guide rod.

SPECS: Steel, blued, matte finish. 2" (4.8cm) long.

Altro...

Istantanea Comp & boccola dare controllo muso, meno rinculo

Tre camere a piena e scarico sette porte si combinano per aiutare il controllo rinculo e muso salire per mettere nuovamente il bersaglio più velocemente. L'installazione è facile come una nuovo barile boccola di montaggio. Si adatta a tutti i calibri di barili Govt-lunghezza con diametro esterno di. 576" a. 580". Richiede minore raccordo e un asta di guida full-length, due pezzi.

Specifiche: acciaio, brunito, finitura opaca. 2"(4,8 cm) lungh.

Altro...

Punteggi dei clienti per WILSON COMBAT MULTI-COMP

Numero di punteggi: 13
Da brownells.com: 13
Punteggio medio: 4.6

Best one to Buy (29.07.2009)

This compensator work. This my third one on my 1911(Colt, Para Ord., and SW). my grouping is less than 1" on 25m.

works as advertized (14.08.2009)

The Multi-comp definitely reduces muzzle rise. It was easy to install.

multi comp (22.02.2010)

great is all i can say, this was truly a drop in addition to my pistol and on top of making it look even more awsome it also reduces the muzzle flip a little bit. it added just over 1 1/4"s to the overall length, and it was a great addition to my pistol. along side the black gritty punisher grips and the 10 round mags that i have purchased for it this tops all of them. there was no fitting required at all.

Good full size compensator. (08.01.2011)

Every review about drop-in fit is accurate. If you are performing a custom build like I did, here are a few things I ran across. Pre-measure your opening on your slide and the comp. OD. I had to mill off .0015" for a nice snug fit. My set up was with an STI 6" long slide and barrel which extended just beyond the slide. Checking proper fit I found that I had to lathe about .002" from the ID of the comp. to clear the barrel. Wilson also recommends shortening the spring plug to 1.2".
Hope this helps.

.45 Comp (26.01.2011)

Great addition to my custom .45. Gives it a more tactical look and increases it's "scare factor". It was difficult to install, and it's curves don't quite match up with the slide. Slightly noticeable difference in recoil as well helps with faster follow-up shots. On the full size 1911 it almost makes it awkwardly long as far as carry and look goes so in my opinion would look better on a commander sized or smaller.

Well worth the effort (06.03.2011)

THis took considerable fitting on my S&W 1911. Not a hard process but time consuming. I installed it with a Wolf 14# reduced power main spring and the Wilson 2 piece guide rod w shock buffer. I shot the gun side by side with a stock S&W 1911 and could readily feel the difference with ammo ranging from target velocity 200 gr loads to factory ball. Considerably less muzzle flip and felt recoil on all loads. Accuracy may have been slightly improved as well. It's a bit of a pain to clean but well worth it IMHO

I'd have given it a 5 if it was true drop in.

Awesome product (12.03.2012)

I use this on my Kimber 45 for shooting targets and hunting. It is the best investment that I have made for my Kimber so far. As it says in the details mill work is required and anyone who gives a bad rating for that reason did not read or understand what is written.

Fit and Finish (09.04.2012)

Instructions say "May need to be fitted". This was absolutely NOT the case with the Springfield M1911 A1. Tolerances are slightly different from gun to gun, but with moderate pressure and twist, the part fit the Springfield very nicely. Noticable difference in recoil and it looks good. Thank you Brownells and Wilson Combat

Works and looks great! (03.02.2013)

This was a drop in fit for my 1911! The first time I had it to the range I noticed a big difference in muzzle jump, and my follow up shots were a lot quicker. This looks really awesome as well!

Awesome product! READ THE INSTRUCTIONS! (10.08.2013)

I bought this for my Colt 1991 1A, it took some time to get the OD of the comp to the correct diameter, THIS IS NOT A "DROP IN" part! Take your time, check the fit periodically (You don't want any slop here) also I highly recommend you also get the WC 2 piece guide rod for the spring, I did not have to remove any of the spring at all but assembly is much easier with the two piece rod, not to mention its another great upgrade as it keeps any spring binding from happening, just read the instructions

REALLY HAPPY (16.04.2014)

PUT THIS ON MY ISRAEL ARMS M-5000 GAL, TOOK JUST A FEW MINS TO DO SOME VERY SMALL FITTING. WORKS LIKE A CHARM AND LOOKS GOOD TOO!

Stainless Multi-Comp on SA 1911 "Loaded" (25.05.2015)

Added the Stainless Multi-Comp to my Springfield Armory "Loaded" 1911. The I.D. of the comp matched the O.D. of the SA barrel perfectly. My dial caliper showed a .0015" difference -- just enough for a thin film of lubricant! I use this 1911 in IDPA at our local range at it has helped. In "regular" target shooting, I consistently shoot 2" groups at 10 yards and that's shooting 8 rounds in 10 seconds. A very nice addition to a great 1911!

<img width="500" src='/userdocs/reviewimages/230cdbea-66b5-42c5-8813-40a144d8db46.jpg' alt=''>

Use Caution. (12.06.2015)

Very nice looking addition to my Springfield Range Officer. Installation is time consuming and it took quite a bit of time and emery cloth to get it to fit the slide. Barrel fit perfectly with no adjustments needed.

The caution is, at least with my Range Officer it makes dissassembly much more difficult as the front spring plug cannot be remove or installed with the Multi-Comp installed on the slide. plug must be installed, then the Multi-Comp, then the spring and spring guide held in place by hand and installed on the lower. Tricky to say the least.

Leggi più recensioni su brownells.com

129.9 129.9 1 CHF

N. prodotto: 965397001
WILSON COMBAT MULTI-COMP
Parti Fabbricante: 397 874218001674 Tre camere a piena e scarico sette porte si combinano per aiutare il controllo rinculo e muso salire per mettere nuovamente il bersaglio più velocemente. L'installazione è facile come una nuovo barile boccola di montaggio. Si adatta a tutti i calibri di barili Govt-lunghezza con diametro esterno di. 576" a. 580". Richiede minore raccordo e un asta di guida full-length, due pezzi.

129.9 CHF 0 CHF 129.90 *

In arretrato, tempi di consegna circa 4-12 settimane dal magazzino negli Stati Uniti.

Caratteristiche: Adatto per: 1911 Modello: Government

Aggiungi alla lista degli acquisti

Domande

Dettagli

Aggiungi alla lista degli acquisti

Domande

Caratteristiche

Adatto per: 1911 Modello: Government Peso della spedizione: 0.059kg Altezza di spedizione: 28mm Larghezza di spedizione: 79mm Lunghezza di spedizione: 122mm

Dettagli dell'elemento

Made in Usa

Instant Comp & Bushing Give Muzzle Control, Less Recoil

SPECS: Steel, blued, matte finish. 2" (4.8cm) long.

Altro...

Istantanea Comp & boccola dare controllo muso, meno rinculo

Specifiche: acciaio, brunito, finitura opaca. 2"(4,8 cm) lungh.

Altro...

Punteggi dei clienti per WILSON COMBAT MULTI-COMP

Numero di punteggi: 13
Da brownells.com: 13
Punteggio medio: 4.6

Best one to Buy (29.07.2009)

This compensator work. This my third one on my 1911(Colt, Para Ord., and SW). my grouping is less than 1" on 25m.

works as advertized (14.08.2009)

The Multi-comp definitely reduces muzzle rise. It was easy to install.

multi comp (22.02.2010)

Good full size compensator. (08.01.2011)

.45 Comp (26.01.2011)

Well worth the effort (06.03.2011)

Awesome product (12.03.2012)

Fit and Finish (09.04.2012)

Works and looks great! (03.02.2013)

This was a drop in fit for my 1911! The first time I had it to the range I noticed a big difference in muzzle jump, and my follow up shots were a lot quicker. This looks really awesome as well!

Awesome product! READ THE INSTRUCTIONS! (10.08.2013)

REALLY HAPPY (16.04.2014)

PUT THIS ON MY ISRAEL ARMS M-5000 GAL, TOOK JUST A FEW MINS TO DO SOME VERY SMALL FITTING. WORKS LIKE A CHARM AND LOOKS GOOD TOO!

Stainless Multi-Comp on SA 1911 "Loaded" (25.05.2015)

Use Caution. (12.06.2015)

Leggi più recensioni su brownells.com

Scelti da altri clientie

WILSON COMBAT 2-PIECE GOVERNMENT GUIDE ROD
1911 RECOIL SPRING GUIDE

WILSON COMBAT

In magazzino

CHF 54.90 * CHF 49.90 - CHF 64.90*

Guidamolla

4.6

PACHMAYR 1911 LEGEND FINGER GROOVE GRIPS ROSEWOOD
1911 AMERICAN LEGEND GRIPS

PACHMAYR

In magazzino

CHF 64.90 * CHF 64.90 - CHF 74.90*

Guancette

4.6

WILSON COMBAT VALUE SEAR
1911 VALUE LINE HAMMER & SEAR

WILSON COMBAT

In magazzino

CHF 32.90 * CHF 32.90 - CHF 54.90*

Sear | Cane

4.6

WILSON COMBAT SHOK-BUFFS® PAK
1911 SHOK-BUFFS®

WILSON COMBAT

In magazzino

CHF 17.90 *

Ammortizzatori molla di recupero

3.9

WILSON COMBAT BLUED EZ-LOADER
1911 EZ-LOADER MAGWELL

WILSON COMBAT

In magazzino

CHF 54.90 * CHF 54.90 - CHF 59.90*

Dorsalino

4.1

Accesso

Hai dimenticato la password?
Registrati

SOCIAL MEDIA

Facebook

BROWNELLS.CH

CATALOGO PRODOTTI

ORDINARE

CUSTOMER SERVICE

Benvenuti!

Benvenuti su Brownells.ch, il principale rivenditore online di accessori per armi da fuoco, componenti di pistole e utensili per armaioli in Svizzera!

La nostra offerta

Se ti piace sparare, lavorare sulle armi da fuoco come artigiano o per hobby, o semplicemente possiedi un'arma, questo è il posto per te! Grazie alla nostra grande esperienza, ogni giorno, tiratori, armaioli professionisti, hobbisti, militari, esponenti delle forze dell'ordine e appassionati d'armi si rivolgono a Brownells.ch per trovare accessori e componenti di alta qualità e fare rifornimento di ciò di cui hanno bisogno.