Caractéristiques
- Poids du colis: 0.567kg
- Hauteur d'expédition: 91mm
- Largeur d'expédition: 94mm
- Longueur d'expédition: 277mm
- UPC: 757253718014
Le prix inclut la TVA mais pas la livraison .
Référence: 749007261
N° fabr.: 010482
757253718014 La performance précise de vos munitions dépend absolument de l'uniformité à la fois de la balle et de la douille. Atteindre cette uniformité n'est pas possible sans un appareil de mesure précis et fiable. L'inspecteur Co-Ax Case & Cartridge de Forster vous permet d'assurer cette uniformité en mesurant trois dimensions critiques : l'épaisseur de la paroi du col, la concentricité du col de la douille et le runout de la balle. Les mesures se font par incréments d'un millième de pouce, ce qui garantit une précision exceptionnelle. L'inspecteur est unique car il vérifie à la fois l'alignement de la balle et de la douille par rapport à l'axe central de l'ensemble de la cartouche ou de la douille. L'inspecteur de douille Forster utilise des pilotes de taille de douille Forster (vendus séparément).Useful 11.09.2017
I agree with the above review about the difficulty of set up and the V groove. The tool is tedious to setup, and when you change over from checking concentricity to checking T.I.R. it again takes time to get all the adjustments made. It isn't the most efficient process and the tool really can't handle a long cartridge witout the case head compression spring pushing the meplat into the adjustment bar, though it is very useful for checking case neck thickness. I'm not a competitive shooter where I need every little bit of accuracy, but I do like to build very consistent rounds. Knowing what I do now I would have purchased the Sinclair concentricity guage instead
So so tool 28.09.2013
The v groove holder the bullet sits in was very rough from the factory. So much so that within a few turns it was cutting the copper on the bullet. little time with a dremmel and a stone and polish wheel cleaned it up glass smooth and the problem is gone. It takes a little bit to get the tool setup right so all the angles jive but once done it seems to work pretty well. One thing to note though is if the meplat is not perfect you will not get a good measurement. There is a spring that pushes the round against an anvil where the v groove piece above is. This causes the round to wobble a little giving inaccurate measurements if you are not careful. Need to put a little sizing wax on the rear v section where the case rolls to make it smooth.
Overall it works well once you take the time to properly adjust everything but is definitely not a tool for the impatient!
Nous avons rencontré une erreur lors du chargement de ce contenu. Veuillez actualiser la page pour continuer. Si le problème persiste, contactez notre service client.