Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.604" Overall Width: .99" Mounting Hardware: (2) 6-32 Button Head Screws, (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw Red Dot Fitment: Vortex Viper/Venom, Burris FastFire, Crimson Trace CTS-1200, CTS-1300, Docter EGW's red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with our mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation.
Mount per il mirino red dot CZ Shadow 2 - Alta qualità e precisione!
Presentiamo il CZ SHADOW 2 LEUPOLD DELTAPOINT PRO SIGHT MOUNT e il CZ SHADOW 2 VORTEX LEUPOLD DELTAPOINT PRO SIGHT MOUNT, progettati da EGW. Questi supporti sono realizzati in alluminio 7075 con un rivestimento nero opaco, offrendo una durabilità e una resistenza superiori.
Specifiche del prodotto:
- Materiale: Alluminio 7075
- Rivestimento: Nero opaco Hardcoat
- Dimensioni:
- Lunghezza totale: 1.604"
- Larghezza totale: .99"
- Hardware di montaggio:
- (2) Viti a testa a bottone 6-32
- (2) Viti a testa piatta 6-32
- (1) Vite di bloccaggio 6-32
- Compatibilità con Red Dot: Vortex Viper/Venom, Burris FastFire, Crimson Trace CTS-1200, CTS-1300, Docter
Istruzioni per l'installazione:
- Rimuovere il mirino posteriore*
- Installare il supporto EGW nella guida a coda di rondine
- Serrare la vite di bloccaggio (se applicabile)
- Posizionare il mirino red dot sul supporto EGW (inserire un piccolo pezzo di carta tra il mirino red dot e il supporto faciliterà la rimozione e proteggerà il mirino dal Loctite).
- Applicare Loctite blu sulle viti di montaggio fornite
- Serrare le viti di montaggio a 15 in/lbs
Nota:
Le viti incluse richiedono una chiave a brugola da 5/64'' per l'installazione.
Non è necessaria alcuna modifica al vostro fucile. Potete rimuovere il nostro supporto e sostituire il mirino posteriore in qualsiasi momento. Hardware di montaggio incluso.