Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Mount per Trijicon RMR per CZ SHADOW 2
Presentiamo il montaggio per il mirino Trijicon RMR, progettato specificamente per la CZ SHADOW 2. Questo montaggio è realizzato in alluminio 7075 e presenta un rivestimento in nero opaco per una maggiore durabilità e resistenza.
Descrizione del Prodotto
- Materiale: Alluminio 7075
- Rivestimento: Nero Opaco Hardcoat
- Lunghezza Totale: 1.780"
- Larghezza Totale: 1.1"
- Hardware di Montaggio: (2) Viti Piatte 6-32, (1) Vite di Blocco 6-32 X 3/16
- Compatibilità del Red Dot: Trijicon RMR, Holosun HS507C
Compatibilità
Questo montaggio si adatta a:
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
Questo montaggio non è compatibile con:
Istruzioni di Installazione
- Rimuovere il mirino posteriore*
- Installare il montaggio EGW nel dovetail
- Serrare la vite di bloccaggio (se applicabile)
- Posizionare il mirino red dot sul montaggio EGW (mettere un piccolo pezzo di carta tra il mirino red dot e il montaggio renderà più facile la rimozione e manterrà il Loctite lontano dal mirino red dot.)
- Applicare Loctite blu alle viti di montaggio fornite
- Serrare le viti di montaggio a 15in/lbs
Nota: Le viti incluse con questo montaggio richiedono una chiave a brugola da 5/64'' per l'installazione.