EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: Desert Eagle Post 2017 Baby Desert Eagle Post 2006 Please take note to the Pre 2017 and Post 2017 differences when placing your order. Pre 2017 rear shelf behind the dovetail is .187" Post 2017 rear shelf behind the dovetail is .120"
Erlebe die Präzision mit dem EGW Sight Mount für den Desert Eagle!
Der EGW Sight Mount ist die perfekte Lösung, um dein Leupold DeltaPoint Pro, JPoint, Redfield Accelerator oder Optima Rotpunktvisier auf deinem Desert Eagle Pre 2017 zu montieren. Hier sind die Details:
Produktbeschreibung
Die EGW Rotpunktvisiere sind so konzipiert, dass sie von links nach rechts (mit dem Lauf nach vorne) installiert werden. Die Dovetail hat eine progressive Taperung, die die Montage erleichtert. Entferne einfach das hintere Visier deiner Waffe und ersetze es durch die EGW Halterung.
Installation
- Entferne das hintere Visier*
- Installiere die EGW Sight Mount in der Dovetail
- Ziehe die Set-Schraube fest (falls zutreffend)
- Platziere das Rotpunktvisier auf der EGW Sight Mount (ein kleines Stück Papier zwischen dem Rotpunktvisier und der Halterung erleichtert die Entfernung und hält Loctite vom Rotpunktvisier fern)
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf
- Ziehe die Montageschrauben mit 15 in/lbs an
Die Modifikation deiner Feuerwaffe kann die Herstellergarantie ungültig machen. Dieses Produkt sollte von einem qualifizierten Büchsenmacher installiert und überprüft werden. Es wird keine Haftung für Schäden oder Verletzungen übernommen, die aus unsachgemässer Installation oder Verwendung dieses Produkts resultieren könnten.
Wichtige Hinweise
Diese Halterung passt nicht auf:
- Desert Eagle Post 2017
- Baby Desert Eagle Post 2006
Bitte achte auf die Unterschiede zwischen Pre 2017 und Post 2017, wenn du deine Bestellung aufgibst.
- Pre 2017 hinterer Regal hinter der Dovetail ist .187"
- Post 2017 hinterer Regal hinter der Dovetail ist .120"