EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Please take note to the Pre 2017 and Post 2017 differences. Pre 2017 rear shelf behind the dovetail is .187"" and Post 2017 is .120".
Montiere deine Vortex Viper/Venom mit Leichtigkeit!
Die EGW Sight Mount für die Desert Eagle Pre 2017 ermöglicht dir eine einfache Installation deiner Vortex Viper/Venom, Burris FastFire oder Docter Rotpunktvisiere. Hier sind die Details:
Produktbeschreibung
Die EGW Rotpunktvisiere sind so konzipiert, dass sie von links nach rechts installiert werden (mit dem Lauf nach vorne gerichtet). Der Dovetail hat eine progressive Verjüngung, die die Installation erleichtert. Entferne einfach das hintere Visier deiner Waffe und ersetze es durch die EGW Halterung, um dein Vortex Viper/Venom zu montieren. Es sind keine Änderungen erforderlich. Du kannst die Halterung jederzeit abnehmen und dein hinteres Visier wieder anbringen.
Installationsanleitung
- Entferne das hintere Visier*
- Installiere die EGW Sight Mount im Dovetail
- Ziehe die Set-Schraube fest (falls zutreffend)
- Platziere das Rotpunktvisier auf der EGW Sight Mount (ein kleines Stück Papier zwischen dem Rotpunktvisier und der Halterung erleichtert die Entfernung und hält Loctite vom Rotpunktvisier fern.)
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf
- Ziehe die Montageschrauben mit 15 in/lbs an
Mitgeliefertes Zubehör
- 2 Button Head Cap Screws - Für Vortex Viper und Venom Sights
- 2 Flat Head Cap Screws - Für Burris FastFire und Docter Sights
Die mit dieser Halterung gelieferten Schrauben benötigen einen 5/64'' Inbusschlüssel für die Installation. Bitte achte auf die Unterschiede zwischen Pre 2017 und Post 2017. Das hintere Regal hinter dem Dovetail beträgt bei Pre 2017 .187" und bei Post 2017 .120".