EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount will not work with FN FNP or FN 5.7.
Améliore ton tir avec le montage EGW pour Vortex Viper/Venom
Le montage EGW pour les lunettes de visée Vortex Viper/Venom est conçu pour s'installer facilement sur ton FN FNS ou FNX. Voici comment cela fonctionne :
Caractéristiques du produit :
- Installation facile : Les lunettes de visée red dot EGW s'installent de gauche à droite (avec le canon orienté vers l'avant).
- Conception en queue d'aronde : La queue d'aronde a un taper progressif pour faciliter l'installation.
- Remplacement rapide : Retire simplement la hausse arrière de ton arme et remplace-la par le montage EGW pour fixer ta lunette Vortex Viper/Venom, Burris FastFire ou Docter.
- Matériel de montage inclus : Tout ce dont tu as besoin pour l'installation est fourni.
Instructions d'installation :
- Retire la hausse arrière*
- Installe le montage EGW dans la queue d'aronde
- Serre la vis de réglage (si applicable)
- Place la lunette red dot sur le montage EGW (mettre un petit morceau de papier entre la lunette et le montage facilitera le retrait et évitera que le Loctite n'atteigne la lunette).
- Applique du Loctite bleu sur les vis de montage fournies
- Serre les vis de montage à 15 in/lbs
Vis fournies :
- 2 vis à tête bombée - Fournies pour les lunettes Vortex Viper et Venom
- 2 vis à tête plate - Fournies pour les lunettes Burris FastFire et Docter
Les vis incluses avec ce montage nécessitent une clé Allen de 5/64'' pour l'installation.
Attention : La modification de ton arme à feu peut annuler la garantie du fabricant. Ce produit doit être installé et vérifié par un armurier qualifié. Aucune responsabilité n'est exprimée ou implicite pour les dommages ou blessures pouvant résulter d'une installation ou d'une utilisation incorrecte de ce produit. Ce montage ne fonctionnera pas avec FN FNP ou FN 5.7.