EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
Montaggio semplice e preciso per il tuo S&W M&P 22 Compact
Il montaggio per il punto rosso S&W M&P 22 Compact Vortex Viper/Venom di EGW è progettato per un'installazione facile e veloce. Questo prodotto è compatibile con i punti rossi Vortex Viper e Venom, garantendo un'ottima visibilità e precisione durante il tiro.
Descrizione del prodotto
Le mire a punto rosso EGW devono essere installate da sinistra a destra (con la bocca rivolta in avanti). La guida a coda di rondine presenta un'inclinazione progressiva per facilitare l'installazione. Basta rimuovere la mira posteriore della tua arma e sostituirla con il montaggio EGW per installare il tuo punto rosso Vortex Viper/Venom, Burris FastFire o Docter.
È possibile rimuovere il montaggio e ripristinare la mira posteriore in qualsiasi momento. Hardware di montaggio incluso.
Istruzioni per l'installazione
- Rimuovere la mira posteriore*
- Installare il montaggio EGW nella guida a coda di rondine
- Serrare la vite di bloccaggio (se applicabile)
- Posizionare il punto rosso sul montaggio EGW (inserire un piccolo pezzo di carta tra il punto rosso e il montaggio faciliterà la rimozione e manterrà il Loctite lontano dal punto rosso)
- Applicare Loctite blu alle viti di montaggio fornite
- Serrare le viti di montaggio a 15in/lbs
Viti fornite:
- 2 Viti a testa bombata - Fornite per i punti Vortex Viper e Venom
- 2 Viti a testa piatta - Fornite per i punti Burris FastFire e Docter
Le viti incluse con questo montaggio richiedono una chiave a brugola da 5/64'' per l'installazione.
La modifica della tua arma potrebbe annullare la garanzia del produttore. Questo prodotto dovrebbe essere installato e controllato da un armaiolo qualificato. Non si assume alcuna responsabilità per danni o infortuni che potrebbero derivare da un'installazione o un uso improprio di questo prodotto.