Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Améliore ton tir avec le montage de viseur arrière fixe KIMBER!
Le montage de viseur arrière fixe KIMBER pour Trijicon RMR est conçu pour offrir une solution fiable et durable pour tes besoins de tir. Fabriqué en aluminium 7075 avec un revêtement matte black hardcoat, ce montage est non seulement léger mais également résistant.
Caractéristiques du produit :
- Longueur totale : 1.780"
- Largeur totale : 1.1"
- Matériel : Aluminium 7075
- Vis de montage incluses : (2) vis à tête plate 6-32, (1) vis de réglage 6-32 X 3/16
Compatibilité :
Ce montage est compatible avec :
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
Ce montage ne convient pas : Rock Island 1911s
Installation :
Pour installer le montage, suis ces étapes simples :
- Retire le viseur arrière de ton arme.
- Installe le montage de viseur EGW dans la queue d'aronde.
- Serre la vis de réglage (si applicable).
- Place le viseur à point rouge sur le montage EGW (mettre un petit morceau de papier entre le viseur et le montage facilitera le retrait et empêchera le Loctite de se coller au viseur).
- Applique du Loctite bleu sur les vis de montage fournies.
- Serre les vis de montage à 15 in/lbs.
Outils nécessaires :
Les vis incluses avec ce montage nécessitent une clé Allen de 5/64'' pour l'installation.
Améliore ta précision de tir dès aujourd'hui avec le montage de viseur arrière fixe KIMBER pour Trijicon RMR!