Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.811" Overall Width: .99" Mounting Hardware: (2) 6-32 Button Head Screws, (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw Red Dot Fitment: Vortex Viper/Venom, Burris FastFire, Crimson Trace CTS-1200, CTS-1300, Docter. FITS: Sig P210 Target (American Only Post 2016) EGW's red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with our mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation.
Präzise Montage für dein SIG SAUER P210A TARGET
Mit der SIG SAUER P210A TARGET VORTEX VIPER/VENOM SIGHT MOUNT von EGW kannst du deine Zielgenauigkeit erheblich verbessern. Diese Montage ist speziell für dein SIG P210 Target (nur amerikanische Modelle nach 2016) konzipiert.
Produktdetails:
- Material: 7075 Aluminium
- Beschichtung: Matte Black Hardcoat
- Gesamtlänge: 1.811"
- Gesamtbreite: .99"
- Montagehardware: (2) 6-32 Button Head Screws, (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw
- Red Dot Kompatibilität: Vortex Viper/Venom, Burris FastFire, Crimson Trace CTS-1200, CTS-1300, Docter
Installation:
Die Montage ist einfach zu installieren:
- Entferne die Kimme deines Gewehrs.
- Installiere die EGW Sight Mount in der Dovetail.
- Ziehe die Set Screw (falls zutreffend) fest.
- Setze das Red Dot Sight auf die EGW Sight Mount. (Ein kleines Stück Papier zwischen dem Red Dot Sight und der Montage erleichtert die Entfernung und hält Loctite vom Red Dot Sight fern.)
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf.
- Ziehe die Montageschrauben mit 15 in/lbs fest.
Mitgelieferte Schrauben:
- 2 Button Head Cap Screws - Für Vortex Viper und Venom Sights
- 2 Flat Head Cap Screws - Für Burris FastFire und Docter Sights
Die Schrauben, die mit dieser Montage geliefert werden, erfordern einen 5/64'' Inbusschlüssel für die Installation.