SPB MUZZLE BRAKES These fit the plan B type mounts. Always use an alignment rod to ensure that the entire system is set up correctly. Make sure all surfaces are cleaned and the muzzle device has been torqued and Rockset to the barrel. Use on a Q can voids your warranty, be warned. Torque the muzzle device to approximately 15-25ft lbs. Make sure the muzzle device is square against the shoulder. When setting the silencer on the muzzle device, ensure that the threads and tapers are clean. Torque the suppressor to 10 ft lbs. Ensure alignment. Enjoy. The nitride finish does lead to a tighter seal, with that said, it is extremely important to torque and rockset your muzzle device to the barrel properly. FEATURES: 17-4 PH H900 Atlas and Atlas XL Compatible Plan B Compatible Atlas Adapter Overrun Approximately 1.050″ Atlas XL Adapter No Overrun Black Nitride Finish (67 HRC Surface Hardness) Shims Included* EXCEPT *Shims not included with the SR25/M110 or 11/16×24
Entdecke die SPB MUZZLE BRAKES für deine Waffen!
Die SPB MUZZLE BRAKES passen perfekt zu den Plan B Montagen. Achte darauf, immer einen Ausrichtungsstab zu verwenden, um sicherzustellen, dass das gesamte System korrekt eingerichtet ist. Reinige alle Oberflächen gründlich und stelle sicher, dass das Mündungsgerät fest angezogen und mit Rockset am Lauf befestigt ist. Die Verwendung mit einem Q-Dämpfer kann deine Garantie ungültig machen, sei gewarnt.
Installation
- Drehmoment des Mündungsgeräts auf etwa 15-25 ft lbs einstellen.
- Stelle sicher, dass das Mündungsgerät rechtwinklig zur Schulter sitzt.
- Beim Anbringen des Schalldämpfers auf dem Mündungsgerät, achte darauf, dass die Gewinde und Konen sauber sind.
- Drehmoment des Schalldämpfers auf 10 ft lbs einstellen.
- Sichere die Ausrichtung.
Geniesse die Vorteile! Die Nitride-Beschichtung sorgt für eine engere Abdichtung. Es ist daher äusserst wichtig, dein Mündungsgerät ordnungsgemäss am Lauf anzuziehen und mit Rockset zu sichern.
Merkmale:
- 17-4 PH H900
- Kompatibel mit Atlas und Atlas XL
- Plan B kompatibel
- Atlas Adapter Überlauf ca. 1.050″
- Atlas XL Adapter ohne Überlauf
- Schwarze Nitride-Oberfläche (67 HRC Oberflächenhärte)
- Shimms enthalten* AUSSER *Shims nicht enthalten bei SR25/M110 oder 11/16×24