EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with the mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
Perfekte Montage für deine Vortex Viper/Venom auf Taurus G2/G3!
Die EGW Red Dot Sights sind so konzipiert, dass sie von links nach rechts (mit dem Lauf nach vorne) installiert werden. Der Dovetail hat eine progressive Taper, um die Installation zu erleichtern.
Einfach das hintere Visier deines Gewehrs entfernen und durch die Montage ersetzen, um dein Vortex Viper/Venom, Burris FastFire oder Docter Red-Dot Visier zu montieren. Du kannst die Montage jederzeit abnehmen und dein hinteres Visier wieder anbringen.
Montageanleitung:
- Entferne das hintere Visier*
- Installiere die EGW Sight Mount im Dovetail
- Ziehe die Set-Schraube an (falls zutreffend)
- Platziere das Red Dot Sight auf der EGW Sight Mount (ein kleines Stück Papier zwischen dem Red Dot Sight und der Sight Mount erleichtert die Entfernung und hält Loctite vom Red Dot Sight fern.)
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf
- Ziehe die Montageschrauben auf 15 in/lbs an
Mitgelieferte Schrauben:
- 2 Button Head Cap Screws - für Vortex Viper und Venom Sights
- 2 Flat Head Cap Screws - für Burris FastFire und Docter Sights
Die mit dieser Montage gelieferten Schrauben benötigen einen 5/64'' Inbusschlüssel für die Installation.
Eine Modifikation deines Feuergewehrs kann die Garantie des Herstellers ungültig machen.
Dieses Produkt sollte von einem qualifizierten Büchsenmacher installiert und überprüft werden.
Es wird keine Haftung für Schäden oder Verletzungen übernommen, die aus unsachgemässer Installation oder Nutzung dieses Produkts resultieren können.