Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Kompakte und robuste Lösung für dein Trijicon RMR Rotpunktvisier!
Der S&W REVOLVER TRIJICON RMR SIGHT MOUNT von der Marke EGW ist die perfekte Ergänzung für dein Setup. Hier sind die Details:
- Material: 7075 Aluminium
- Beschichtung: Matte Black Hardcoat
- Gesamtlänge: 1.780"
- Gesamtbreite: 1.1"
- Befestigungsmaterial: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
- Kompatibilität: Trijicon RMR, Holosun HS507C
Dieser Mount passt auf:
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
Dieser Mount passt nicht auf:
Um dein Trijicon RMR Rotpunktvisier zu montieren, entferne einfach die hintere Visierung deines Gewehrs und ersetze sie durch unseren Mount. Es sind keine Änderungen erforderlich. Du kannst unseren Mount jederzeit abnehmen und deine hintere Visierung wieder anbringen. Das Befestigungsmaterial ist im Lieferumfang enthalten.
Montageanleitung
- Die hintere Visierung entfernen*
- Den EGW Sight Mount in die Dovetail einsetzen
- Set-Schraube anziehen (falls zutreffend)
- Das Rotpunktvisier auf den EGW Sight Mount setzen (ein kleines Stück Papier zwischen dem Rotpunktvisier und dem Mount erleichtert die Entfernung und schützt das Rotpunktvisier vor Loctite).
- Blaue Loctite auf die mitgelieferten Befestigungsschrauben auftragen
- Befestigungsschrauben mit 15 in/lbs anziehen
2 Flat Head Cap Screws - Im Lieferumfang für Trijicon RMR enthalten. Die mit diesem Mount gelieferten Schrauben benötigen einen 5/64'' Inbusschlüssel für die Installation.