Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Kompakte und präzise Montage für dein Trijicon RMR Rotpunktvisier
Die S&W M&P 22 COMPACT TRIJICON RMR SIGHT MOUNT von EGW ist die perfekte Lösung, um dein Trijicon RMR Rotpunktvisier auf deiner Waffe zu montieren.
Produktdetails:
- Material: 7075 Aluminium
- Beschichtung: Matt Schwarz Hardcoat
- Gesamtlänge: 1.780"
- Gesamtbreite: 1.1"
- Montagehardware: (2) 6-32 Flachkopfschrauben, (1) 6-32 X 3/16 Set-Schraube
- Rotpunkt Passform: Trijicon RMR, Holosun HS507C
Kompatibilität:
Diese Montage passt:
- Baby Desert Eagle (nach 2006)
- EAA Witness Elite Match
Diese Montage passt nicht:
Einfacher Einbau:
Du kannst die hintere Visierung deiner Waffe einfach entfernen und durch unsere Montage ersetzen, um dein Trijicon RMR Rotpunktvisier zu montieren. Es sind keine Änderungen an deiner Waffe erforderlich. Du kannst unsere Montage jederzeit wieder abnehmen und deine hintere Visierung wieder anbringen.
Installationsanleitung:
- Entferne die hintere Visierung*
- Installiere die EGW Sight Mount in der Dovetail
- Ziehe die Set-Schraube fest (falls zutreffend)
- Platziere das Rotpunktvisier auf der EGW Sight Mount (ein kleines Stück Papier zwischen dem Rotpunktvisier und der Montage erleichtert das Abnehmen und verhindert, dass Loctite auf das Rotpunktvisier gelangt).
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf
- Ziehe die Montageschrauben mit 15 in/lbs an
Hinweis: Die mitgelieferten Schrauben benötigen einen 5/64'' Inbusschlüssel für die Installation.