Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs This mount does not fit: FN FNP (the slide radius is too large to allow this mount to fit) FN 5.7 Any Optics Ready Pistol
Perfekte Lösung für deine Leupold DeltaPoint Pro Montage!
Mit der EGW Sight Mount kannst du ganz einfach die hintere Visierung deiner Waffe entfernen und durch die EGW Halterung ersetzen, um dein Leupold DeltaPoint Pro, JPoint, Redfield Accelerator oder Optima Rotpunktvisier zu montieren. Die Halterung kann jederzeit wieder abgenommen und durch die hintere Visierung ersetzt werden.
Installation:
- Entferne die hintere Visierung*
- Installiere die EGW Sight Mount im Dovetail
- Ziehe die Set-Schraube (falls zutreffend) fest
- Setze das Rotpunktvisier auf die EGW Sight Mount (ein kleines Stück Papier zwischen dem Rotpunktvisier und der Halterung erleichtert die Entfernung und hält Loctite vom Visier fern)
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf
- Ziehe die Montageschrauben mit 15 in/lbs an
Diese Halterung passt nicht:
- FN FNP (der Schlittenradius ist zu gross, um diese Halterung zu ermöglichen)
- FN 5.7
- Jede Optics Ready Pistole
* Hinweis: Bitte beachte die Installationshinweise sorgfältig, um eine optimale Funktion zu gewährleisten.