Eigenschaften
- Art: Picatinny
- Innendurchmesser: .750
- Material: Aluminum
- Modell: -
- Waffentyp: AR-15
- Versandgewicht: 0.181kg
- Versandhöhe: 51mm
- Versandbreite: 91mm
- Versandlänge: 127mm
- UPC: 050806107762
Artikeldetails
US-Exportklassifizierung: 0A501.x

Artikel-Nr.: 080000384
050806107762 Der einfach zu installierende Gasblock verfügt über eine integrierte feste Schiene und ein modulares Design, das eine schnelle Installation und Demontage von bis zu drei zusätzlichen Picatinny-Schienen für die Montage von Lasern, Lichtern, Nachtsichtoptiken, Backup-Visieren und einer Vielzahl anderer taktischer Zubehörteile ermöglicht. Seiten- und Bodenschienen lassen sich einfach mit zwei Schrauben anbringen, sodass du die Einheit für die Anforderungen jeder Mission konfigurieren kannst. Präzisionsbearbeitet aus robustem 6061 Billet-Aluminium für überlegene Festigkeit, ohne dein Gewehr zusätzlich zu belasten. Lässt sich sicher mit drei gehärteten Stahl-Schrauben am Lauf montieren.SPECS: Aluminium, matt schwarz, harteloxierte Oberfläche. Passt auf Standard .750" (19mm) Durchmesser Läufe. Gasblock - 1-7⁄8" (4.8cm) lang, 1" (2.5cm) breit, 1-7⁄16" (3.6cm) hoch. Gasblock-Kit – Enthält modularen Gasblock mit drei zusätzlichen Schienen. 1-7⁄8" lang, 2-7⁄64" (5.3cm) breit, 2" (5.0cm) hoch.
gas block - Bayonet Lug. 28.02.2017
we got in the gas block - bayonet lug. went on great - fast, with a AR 15 roll pin starter. add 2 small drops of blue lock tight on all 2 or 4 Alin screws, to be safe!
Great design, terrible material choice 21.02.2016
I purchased this kit for an upper build I was doing as a gift for a friend. The design is fantastic in its versatility but the choice of a low grade and strength aluminum (6061 or 2024) as the manufacturing material was wrong considering the limited length of threaded holes for both clamping to the barrel and attaching the picatinny rail sections. Both the clamping set screws and the screws for attaching rail sections stripped out without any effort and upon examining the screws for the rail sections the screws were only holding on 1-1/2 to 2 complete turns of the thread. Standard manufacturing practice is that when putting a screw into aluminum of any grade you must go twice the diameter of the screw in number of threads to properly hold.
As previously stated this is a fantastic design but would be better off if manufactured out of steel or titanium.
Beim Laden dieses Inhalts ist ein Fehler aufgetreten. Bitte aktualisiere die Seite, um fortzufahren. Wenn das Problem weiterhin besteht, wende dich bitte an unseren Kundenservice.