Eigenschaften
- Modell:
Commander
,Government
- Waffentyp:
1911
- Versandgewicht: 0.018kg
- Versandbreite: 83mm
- Versandlänge: 146mm
Artikel-Nr.: 168000128
Herst.-Nr.: P28BC
Komplettes Set mit 11 präzisionsgeschliffenen Stiften und Plungern zum Renovieren eines bestehenden 1911 oder zum Bau eines neuen von Grund auf. Wärmebehandelt für hervorragende Widerstandsfähigkeit gegen Oberflächenabnutzung für eine lange Lebensdauer. Erhältlich in mattschwarzem Kohlenstoffstahl oder rostfreiem Stahl mit natürlicher Oberfläche.Lieferzeit ca. 2-4 Tage.
Das 1911 PIN SET von CASPIAN ist die ideale Wahl, um jede einzelne Schraube in deiner Pistole zu ersetzen. Es ist hitzegehärtet für erhöhte Stärke und Langlebigkeit.
Dieses komplette Set umfasst 11 präzise geschliffene Pins und Plunger, die perfekt geeignet sind, um eine bestehende 1911 zu renovieren oder eine neue von Grund auf zu bauen. Die Pins sind wärmebehandelt und bieten hervorragenden Widerstand gegen Oberflächenabnutzung für eine lange Lebensdauer.
Kompatibel mit 1911 Government Model, Commander und Klonen; passt nicht auf das Officers Model.
Commander,
Government
1911
Buyer Beware 27.12.2011
I bought this set of pins to finish out a 1911 build I'm doing for my wife. I ordered the Caspian Race Ready Receiver (168-100-110) for the build, so I figured I'd order this pin set since it's made by the same manufacturer. The ejector pin in this set is solid, and I think it's slightly oversize, as it bent while I was trying to install it into the ejector pin hole (yes, I had done the requisite notching of the ejector post, and there was no blocking of the hole when I looked thru it; I also should have measured the diameter of the pin against the diameter of the hole--I really think a roll pin is better for this application).
Additionally, if you decide to use the Cylinder and Slide Professional Trigger Kit (206-000-019), the hammer strut pin in this set is too large (the pin is .095 and the hole in the hammer is about .093). I reamed out the hole in the hammer, but it was still a very hard pin to drive in.
In the future, I will probably order a different set of pins. I may or may not order Caspian pins again, I haven't yet decided. The mainspring parts are all fine, as are the plunger pins and the sear and hammer pins.
I want to caveat the "Would you recommend this to a friend" question by saying I would recommend it, but I would also tell them what I experienced.
Beim Laden dieses Inhalts ist ein Fehler aufgetreten. Bitte aktualisiere die Seite, um fortzufahren. Wenn das Problem weiterhin besteht, wende dich bitte an unseren Kundenservice.