Caractéristiques
- Model Number: 0.110'' Sear Pin
- Type d'arme: 1911
- Poids du colis: 0.023kg
- Hauteur d'expédition: 8mm
- Largeur d'expédition: 74mm
- Longueur d'expédition: 178mm
- UPC: 813318022912
Le prix inclut la TVA mais pas la livraison .
Référence: 080000696
813318022912 Des reamers en acier trempé et striés pour ajuster les trous de goupille dans les cadres de 1911, afin d'assurer un pistolet qui fonctionne de manière fluide et serrée. Idéal pour corriger les trous de goupille ovalisés et de taille inférieure. Les poignées en polymère qui remplissent bien la main te donnent une prise sécurisée pour transmettre un maximum de couple de manière fluide et uniforme au trou. Un indispensable pour construire des pistolets sur mesure.SPÉCIFICATIONS : Tige en acier trempé, poignée en polymère. Longueur de coupe de 1½" (3,8 cm).
Must have for 1911 builders 22.09.2018
I purchased this set on the recommendation from two of my instructors at gunsmithing school. I was apprehensive about spending the money on a tool I didn't really think I would use. I instantly changed my mind when starting to fit the grip safety. It would not go into the frame until I reamed it. This makes the job easier and a much better end product. I highly recommend if you plan on building a 1911 the right way. Only real con so far is the labeling is horrible on these and many of them are only .001 difference so you have to measure them each time. I marked the handles but they should be marked clearly from the factory in my opinion.
Nous avons rencontré une erreur lors du chargement de ce contenu. Veuillez actualiser la page pour continuer. Si le problème persiste, contactez notre service client.