Caractéristiques
- Modèle:
Commander
,Government
- Type d'arme:
1911
- Poids du colis: 0.014kg
- Largeur d'expédition: 83mm
- Longueur d'expédition: 146mm
Le prix inclut la TVA mais pas la livraison .
Référence: 168000127
N° fabr.: P28SC
Set complet des 11 goupilles et plongeurs de précision pour rénover un 1911 existant ou pour en construire un nouveau de A à Z. Traité thermiquement pour une résistance exceptionnelle à l'usure de surface et une longue durée de vie. Disponible en acier au carbone bleu mat ou en acier inoxydable à finition naturelle.Délai de livraison environ 8-15 jours depuis l'entrepôt des États-Unis.
Le prix inclut la TVA mais pas la livraison .
Le 1911 PIN SET de la marque CASPIAN est la solution parfaite pour remplacer tous les pins de ton pistolet. Chaque pièce est traitée thermiquement pour garantir une résistance et une durabilité exceptionnelles.
Ce set complet comprend les 11 pins et plongeurs usinés avec précision, idéal pour rénover un 1911 existant ou pour en construire un nouveau de toutes pièces. Traité pour résister à l'usure de surface, il assure une longue durée de vie.
Commander,
Government
1911
Buyer Beware 27.12.2011
I bought this set of pins to finish out a 1911 build I'm doing for my wife. I ordered the Caspian Race Ready Receiver (168-100-110) for the build, so I figured I'd order this pin set since it's made by the same manufacturer. The ejector pin in this set is solid, and I think it's slightly oversize, as it bent while I was trying to install it into the ejector pin hole (yes, I had done the requisite notching of the ejector post, and there was no blocking of the hole when I looked thru it; I also should have measured the diameter of the pin against the diameter of the hole--I really think a roll pin is better for this application).
Additionally, if you decide to use the Cylinder and Slide Professional Trigger Kit (206-000-019), the hammer strut pin in this set is too large (the pin is .095 and the hole in the hammer is about .093). I reamed out the hole in the hammer, but it was still a very hard pin to drive in.
In the future, I will probably order a different set of pins. I may or may not order Caspian pins again, I haven't yet decided. The mainspring parts are all fine, as are the plunger pins and the sear and hammer pins.
I want to caveat the "Would you recommend this to a friend" question by saying I would recommend it, but I would also tell them what I experienced.
Nous avons rencontré une erreur lors du chargement de ce contenu. Veuillez actualiser la page pour continuer. Si le problème persiste, contactez notre service client.