Caratteristiche
- Cartuccia: -
- Tipo: Pull-Thru Reamer Sets
- Peso della spedizione: 0.005kg
- Larghezza di spedizione: 83mm
- Lunghezza di spedizione: 89mm
Prezzi comprensivi di IVA più spedizione
N. prodotto: 184300310
N. fab.: HSBUSH
Gli stessi reamer speciali che gli armieri militari utilizzano da tempo per tagliare camere di lunghezza minima sui fucili da competizione, offrendo ai loro tiratori un vantaggio in termini di precisione. Il perno del fucile applica pressione al reamer mentre il reamer viene ruotato dall'estremità della volata. Quando il perno "scende", la camera viene tagliata. Il design migliorato taglia la spalla, il collo e la gola per prevenire la crimpatura del collo delle munizioni. Utilizzare solo come reamer di finitura. Tagliare la camera prima con un reamer di finitura convenzionale. Reamer di qualità superba realizzati secondo le specifiche SAAMI.SPECIFICHE: I set di reamer per .308 e .30-06 includono: Reamer Pull Through (P/T), boccola di spinta e albero di estensione. Albero - lungo 24" (60cm), diametro ¼" (6.3mm), gambo rotondo. Usa #184-054-653 Throater/.22 T-Handle per azionare l'albero. I reamer funzionano su fucili a otturatore o semi-automatici.
Rod and T-handle different Diameters 30.01.2018
The rod shipped measures .267â outside diameter (not the .25â advertised) and the recommended T-handle has an inside diameter of .254â. Customer service said to send it back and they would send it to Clymer to sort out. Mean while I have barrels waiting to get finish reamed.
Great tool!!! 25.09.2017
I used this reamer to finish a short chambered M1 Garand barrel. It worked perfectly.
Not an issue for me as I have training on how to perform this task, but there were no instructions included. It had to be a fluke as I've never purchased any armorer tool from Brownell's that didn't come with instructions.
Patience, plenty of cutting oil and frequent checking are all recommended to prevent going too far. It doesn't take a whole lot of time for a short chamber as this tool cuts very well with minimum effort. I gauge checked and cleaned the tool and bore a number of times. In the end when the bolt closed on the final couple of turns the GO and NO GO gauges confirmed it was dead on spec.
I would definitely recommend this tool for the hobbyist and professional alike.
Si è verificato un errore durante il caricamento di questo contenuto. Aggiorna la pagina per continuare. Se il problema persiste, contatta il nostro servizio clienti.