Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Scopri il montaggio regolabile per la tua pistola!
Presentiamo il KIMBER ADJUSTABLE REAR SIGHT TRIJICON RMR SIGHT MOUNT, un prodotto della marca EGW. Questo montaggio è progettato per adattarsi perfettamente al tuo Trijicon RMR.
Descrizione del prodotto
- Materiale: Alluminio 7075
- Rivestimento: Trattamento duro nero opaco
- Dimensioni:
- Lunghezza totale: 1.780"
- Larghezza totale: 1.1"
- Hardware di montaggio: (2) Viti a testa piatta 6-32, (1) Vite di blocco 6-32 X 3/16
- Compatibilità con Red Dot: Trijicon RMR, Holosun HS507C
- Compatibilità:
- Adatto per: Baby Desert Eagle (Post 2006), EAA Witness Elite Match
- Non adatto per: Rock Island 1911s
Per installare il tuo Trijicon RMR red dot sight, è sufficiente rimuovere il mirino posteriore della tua pistola e sostituirlo con il nostro montaggio. Non sono necessarie modifiche. Puoi rimuovere il nostro montaggio e ripristinare il tuo mirino posteriore in qualsiasi momento. L'hardware di montaggio è incluso.
Istruzioni per l'installazione
- Rimuovere il mirino posteriore*
- Installare il montaggio EGW nel dovetail
- Serrare la vite di blocco (se applicabile)
- Posizionare il red dot sight sul montaggio EGW (mettere un piccolo pezzo di carta tra il red dot sight e il montaggio faciliterà la rimozione e manterrà il Loctite lontano dal red dot sight).
- Applicare Loctite blu alle viti di montaggio fornite
- Serrare le viti di montaggio a 15in/lbs
Nota: Le viti incluse con questo montaggio richiedono una chiave a brugola da 5/64'' per l'installazione.