Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Mount per RMR Trijicon per CZ P10C - Alta qualità e precisione!
Il CZ P10C TRIJICON RMR SIGHT MOUNT della EGW è progettato per offrire una soluzione robusta e affidabile per il montaggio del vostro mirino red dot.
Descrizione del prodotto
- Materiale: Alluminio 7075
- Rivestimento: Hardcoat Nero Opaco
- Dimensioni:
- lunghezza totale: 1.780"
- larghezza totale: 1.1"
- Hardware di montaggio: (2) Viti a testa piatta 6-32, (1) Vite di serraggio 6-32 X 3/16
- Compatibilità Red Dot: Trijicon RMR, Holosun HS507C
- Questo mount si adatta a: Baby Desert Eagle (Post 2006), EAA Witness Elite Match
- Questo mount non si adatta a: Rock Island 1911s
Per installare il mirino red dot Trijicon RMR, basta rimuovere il mirino posteriore della vostra pistola e sostituirlo con il nostro mount. Non sono necessarie modifiche. Potete rimuovere il nostro mount e ripristinare il vostro mirino posteriore in qualsiasi momento. L'hardware di montaggio è incluso.
Istruzioni per l'installazione
- Rimuovere il mirino posteriore*
- Installare il mount EGW nel dovetail
- Serrare la vite di serraggio (se applicabile)
- Posizionare il mirino red dot sul mount EGW (mettere un piccolo pezzo di carta tra il mirino red dot e il mount faciliterà la rimozione e proteggerà il mirino red dot dal Loctite)
- Applicare Loctite blu sulle viti di montaggio fornite
- Serrare le viti di montaggio a 15 in/lbs
Due viti a testa piatta sono fornite per il Trijicon RMR. Le viti incluse con questo mount richiedono una chiave a brugola 5/64'' per l'installazione.