The Enhanced Magazine Release-Continuous Serrations features a slightly curved button surface to fit the natural curvature of your finger. The form fitting curve, along with horizontal serrations, create a self-centering surface that inhibits the finger's vertical movements. The EMR-HC has an uninterrupted surface and serrations, its taller profile makes it easier to press and is only 0.04 taller than the factory magazine release button. When installed, the EMR-HC has a 0.08 protrusion above the mag release button fence on most forged receivers. Due to the EMR-HC's installed height which protrudes 0.08"" over the mag release fence when installed (only 0.06" or 0.07" of the magazine release button travel is needed to drop a magazine), EMR-HC is recommended for 7.62mm ARs only, though it does work on 5.56mm ARs and M16s. For defense and duty ARs and M16s, please use Forward Control Design’s EMR that has only a 0.01" protrusion over most forged receiver magazine release fence. For .308 ARs, the EMR-HC's taller profile will allow you to use AR15/M16 spec mag catch and ambidextrous mag catch/release. An EMR-HC installed on a .308 AR will not protrude over the mag release fence. Machined in 4140 steel and QPQ treated. 308 AR 4140 steel QPQ treated Blind hole magazine release button Curved and serrated or dimpled surface
Rilasciatore di caricatori migliorato per AR .308 – Eccellenza nella funzionalità
Il Rilasciatore di Caricatori Migliorato - Serrature Continue presenta una superficie del pulsante leggermente curva per adattarsi alla naturale curvatura del tuo dito. La curva ergonomica, insieme alle serrature orizzontali, crea una superficie autolocante che inibisce i movimenti verticali del dito.
Caratteristiche principali:
- Superficie continua e serrature per una migliore presa.
- Profilo più alto che facilita la pressione, con un'altezza di soli 0.04" in più rispetto al pulsante di rilascio del caricatore di fabbrica.
- Quando installato, l'EMR-HC sporge di 0.08" sopra la recinzione del pulsante di rilascio del caricatore su molti ricevitori forgiati.
- Consigliato per AR 7.62mm, ma compatibile anche con AR 5.56mm e M16.
- Per AR e M16 da difesa e servizio, si consiglia di utilizzare l'EMR di Forward Control Design, che ha solo 0.01" di sporgenza sopra la recinzione del caricatore.
- Per AR .308, il profilo più alto dell'EMR-HC consente di utilizzare il catch e il rilascio del caricatore in specifiche AR15/M16.
- Un EMR-HC installato su un AR .308 non sporge sopra la recinzione del rilascio del caricatore.
- Realizzato in acciaio 4140 e trattato QPQ.
Specifiche:
- .308 AR
- Acciaio 4140
- Trattamento QPQ
- Pulsante di rilascio del caricatore con foro cieco
- Superficie curva e serrata o a forma di dimple