Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Améliore ton tir avec le montage de viseur TRIJICON RMR pour GLOCK®
Le montage de viseur TRIJICON RMR de EGW est conçu pour s'adapter parfaitement à ton GLOCK®. Voici les détails :
- Matériau : Aluminium 7075
- Revêtement : Mat noir dur
- Longueur totale : 1.780"
- Largeur totale : 1.1"
- Matériel de montage : (2) vis à tête plate 6-32, (1) vis de réglage 6-32 X 3/16
- Compatibilité des points rouges : Trijicon RMR, Holosun HS507C
Attention : Ce montage ne convient pas aux Rock Island 1911s.
Pour installer le viseur Trijicon RMR, il te suffit de retirer le viseur arrière de ton arme et de le remplacer par notre montage. Aucune modification n'est nécessaire. Tu peux retirer notre montage et remplacer ton viseur arrière à tout moment. Le matériel de montage est inclus.
Instructions d'installation
- Retire le viseur arrière*
- Installe le montage de viseur EGW dans la queue d'aronde
- Serre la vis de réglage (si applicable)
- Place le viseur à point rouge sur le montage de viseur EGW (placer un petit morceau de papier entre le viseur à point rouge et le montage facilitera le retrait et empêchera le Loctite de toucher le viseur à point rouge.)
- Applique du Loctite bleu sur les vis de montage fournies
- Serre les vis de montage à 15in/lbs
Deux vis à tête plate sont fournies pour le Trijicon RMR. Les vis incluses avec ce montage nécessitent une clé Allen de 5/64'' pour l'installation.