A third hand for removing the firing pin from Remington and Ruger® bolt action rifles without lost parts or sore fingers that sometimes accompany this tricky job. Install the correct bushing for your rifle in the end of the tool body. Screw the firing pin assembly into the bushing, and tighten the threaded, steel shank to compress and capture the mainspring. The hollow shank protects the firing pin tip as it slides over the pin to compress the spring. The crosspin can then be driven out with a punch, and the spring tension relieved by gradually loosening the shank. Includes bushings for Remington 700 family and Ruger M77® Mark II rifles. Built-in storage slot holds the unused bushing on the tool body, so it’s always there when you need it. NOTE: Will not fit Ruger Left hand actions.
SPECS: Aluminum base, hardcoat anodized, black. Hardened tool steel screw shank and bushings, black oxide finish. Body - 5¼” (13.34cm) long, 1” (2.54cm) wide, 1-3⁄16" (3.02cm) high. Shank – 3½” (8.89cm) long. Fits Remington 700, 710, 721, 722, Model Seven, XP-100, M24, and 40X; Ruger M77 Mark II, 77/22, 77/17, 77/44 bolt action rifles.
Strumento essenziale per la rimozione dei perni di sparo
Un terzo braccio per rimuovere il perno di sparo dai fucili a otturatore Remington e Ruger® senza perdere pezzi o avere le dita doloranti che a volte accompagnano questo lavoro complicato.
Descrizione del Prodotto
Installa il corretto bushing per il tuo fucile all'estremità del corpo dello strumento. Avvita l'assemblaggio del perno di sparo nel bushing e stringi il gambo filettato in acciaio per comprimere e catturare il molla principale. Il gambo cavo protegge la punta del perno di sparo mentre scivola sopra il perno per comprimere la molla. Il perno trasversale può quindi essere estratto con un punzone, e la tensione della molla può essere alleviata allentando gradualmente il gambo.
Include bushings per la famiglia Remington 700 e i fucili Ruger M77® Mark II. La fessura di stoccaggio integrata tiene il bushing non utilizzato sul corpo dello strumento, così è sempre lì quando ne hai bisogno.
Nota: Non si adatta alle azioni sinistrorse Ruger.
Specifiche
- Base in alluminio, anodizzata a duro, nera.
- Gambo e bushings in acciaio per utensili indurito, finitura ossido nero.
- Corpo - 5¼” (13.34cm) di lunghezza, 1” (2.54cm) di larghezza, 1-3/16" (3.02cm) di altezza.
- Gambo – 3½” (8.89cm) di lunghezza.
- Compatibile con Remington 700, 710, 721, 722, Model Seven, XP-100, M24, e 40X; Ruger M77 Mark II, 77/22, 77/17, 77/44 fucili a otturatore.