EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: Desert Eagle Post 2017 Baby Desert Eagle Post 2006 Please take note to the Pre 2017 and Post 2017 differences when placing your order. Pre 2017 rear shelf behind the dovetail is .187" Post 2017 rear shelf behind the dovetail is .120"
Améliore ton tir avec le montage EGW pour Desert Eagle !
Le montage EGW pour le Desert Eagle Pre 2017 est conçu pour accueillir le Leupold DeltaPoint Pro, offrant une installation facile et rapide. Voici ce que tu dois savoir :
Description du produit
Les viseurs à point rouge EGW sont faits pour être installés de gauche à droite (avec le canon orienté vers l'avant). Le rail a un cône progressif qui facilite l'installation. Il te suffit de retirer la hausse arrière de ton arme et de la remplacer par le montage EGW pour installer ton viseur à point rouge.
Instructions d'installation
- Retire la hausse arrière*
- Installe le montage EGW dans le rail
- Serre la vis de réglage (si applicable)
- Place le viseur à point rouge sur le montage EGW (mettre un petit morceau de papier entre le viseur et le montage facilitera le retrait et empêchera le Loctite de se coller au viseur).
- Applique du Loctite bleu sur les vis de montage fournies
- Serre les vis de montage à 15 in/lbs
La modification de ton arme à feu peut annuler la garantie du fabricant. Ce produit doit être installé et vérifié par un armurier qualifié. Aucune responsabilité n'est exprimée ou impliquée pour les dommages ou blessures qui pourraient résulter d'une installation ou d'une utilisation incorrecte de ce produit.
Compatibilité
Ce montage ne convient pas pour :
- Desert Eagle Post 2017
- Baby Desert Eagle Post 2006
Fais bien attention aux différences entre les modèles Pre 2017 et Post 2017 lors de ta commande :
- La hauteur de la plateforme arrière derrière le rail pour Pre 2017 est de .187"
- La hauteur de la plateforme arrière derrière le rail pour Post 2017 est de .120"