EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: Desert Eagle Post 2017 Baby Desert Eagle Post 2006 Please take note to the Pre 2017 and Post 2017 differences when placing your order. Pre 2017 rear shelf behind the dovetail is .187" Post 2017 rear shelf behind the dovetail is .120"
Montaggio preciso e facile per il tuo Desert Eagle
Il DESERT EAGLE PRE 2017 LEUPOLD DELTAPOINT PRO SIGHT MOUNT è progettato per offrire un'installazione semplice e sicura per il tuo Leupold DeltaPoint Pro, JPoint, Redfield Accelerator o Optima red-dot sight.
Descrizione del prodotto
Le mire a punto rosso EGW sono progettate per essere installate da sinistra a destra (con la volata rivolta in avanti). La guida a coda di rondine presenta un taper progressivo per facilitare l'installazione.
- Rimuovi la mira posteriore dalla tua arma.
- Installa il EGW Sight Mount nella guida a coda di rondine.
- Serra la vite di fissaggio (se applicabile).
- Posiziona la mira a punto rosso sul EGW Sight Mount (mettere un piccolo pezzo di carta tra la mira a punto rosso e il mount faciliterà la rimozione e proteggerà la mira a punto rosso dal Loctite).
- Applica Loctite blu alle viti di montaggio fornite.
- Serra le viti di montaggio a 15in/lbs.
La modifica della tua arma potrebbe annullare la garanzia del produttore. Questo prodotto deve essere installato e controllato da un armaiolo qualificato. Non si assume alcuna responsabilità per danni o infortuni che potrebbero derivare da un'installazione o un uso improprio di questo prodotto.
Nota Importante
Questo mount non è compatibile con:
- Desert Eagle Post 2017
- Baby Desert Eagle Post 2006
Si prega di prestare attenzione alle differenze tra Pre 2017 e Post 2017 quando si effettua un ordine:
- La mensola posteriore Pre 2017 dietro la guida a coda di rondine è di .187"
- La mensola posteriore Post 2017 dietro la guida a coda di rondine è di .120"